Move into the pose
Side view
Drag to orbit, pinch or scroll to zoom

Wind-relieving pose

Pavanamuktasana

hold 30 s each side · beginner · move in slowly, hold, come out the same way

Pavanamuktasana, one leg at a time: lying on the back with the left leg long on the mat, the right knee draws in to the chest and both hands clasp the shin just below the knee. The head and shoulders stay down and the long leg stays heavy.

-35°Ankle dorsiflexion
103°Knee flexion
50°Hip flexion
90°Trunk from vertical
53°Arm to trunk
81°Elbow flexion
23Ankle spacing, cm
56Hand spacing, cm
-2Knee outside ankle, cm
–Knee cave, ° inside toe line
–Load left / right, %
0Pelvis drop, cm

Load and joint demand

Bodyweight: no weights. Joint demand below is your own body's weight in this position.

Shoulder, per side
10 / 11

N·m now / peak over the rep.

Faults

Faults grow with knee bend and apply to lifts standing on the floor. The fault check flags a knee caving more than 10° inside the line of the toes and a load split beyond 60/40. Knee cave shows best in the front camera.

Body

Femur changes keep standing height fixed by shortening or lengthening the torso. Longer femurs force more forward lean in any squat.

Muscles worked

Glutes
11 pts
Lower back
9 pts
Abs and core
7 pts

Effort and your quota

2/10 effort2fatigue per set

Hold for 30 seconds on each side: move into the pose slowly, breathe steadily, and come out the way you went in. Yoga is practised for control, balance and mobility, never to failure, so this does not change with your limits.

Level: beginner. One round counts like light conditioning work: 11 legs points, 15 core points.

Prime movers

Gluteus maximus (stretched), spinal erectors (stretched), hip flexors of the long leg (stretched).

What to look for

  • Draw the knee toward the armpit on the same side, not across the body.
  • Keep the long leg straight, the back of the knee toward the mat.
  • Shoulders and head relaxed down; breathe into the belly against the thigh.
How the model works, and its limits

One 3D skeleton drives both views. Segment lengths and widths are Winter's anthropometric ratios of height; segment masses and centre-of-mass positions follow Dempster's data. For free-standing lifts the whole-body angle is found numerically so the combined centre of mass of lifter and load sits over the middle of the foot. Arms and legs use two-link inverse kinematics with a pole direction. Rep timing follows a minimum-jerk profile.

Balance is quasi-static, so ballistic lifts are shown slowed down. Cable pull and pad support forces are not modelled. The spine is one rigid segment and joints have no range-of-motion limits or muscle forces.