Move into the poseBalanced over midfoot
Side view
Drag to orbit, pinch or scroll to zoom

Standing side bend

Indudalasana

hold 15 s each side · beginner · move in slowly, hold, come out the same way

Indudalasana (standing crescent moon). Feet together, legs straight; the arms rise overhead with the palms together, then the whole trunk arches sideways to the left in one long curve while the hips shift a little to the right to stay over the feet. The pelvis is solved over the feet, front to back and side to side.

7°Ankle dorsiflexion
3°Knee flexion
4°Hip flexion
0°Trunk from vertical
22°Arm to trunk
32°Elbow flexion
12Ankle spacing, cm
56Hand spacing, cm
1Knee outside ankle, cm
–Knee cave, ° inside toe line
50 / 50Load left / right, %
0Pelvis drop, cm

Load and joint demand

Bodyweight: no weights. Joint demand below is your own body's weight in this position.

Knee flexors
11 / 11
Calves
29 / 29
Shoulder, per side
3 / 12

N·m now / peak over the rep.

Faults

Faults grow with knee bend and apply to lifts standing on the floor. The fault check flags a knee caving more than 10° inside the line of the toes and a load split beyond 60/40. Knee cave shows best in the front camera.

Body

Femur changes keep standing height fixed by shortening or lengthening the torso. Longer femurs force more forward lean in any squat.

Muscles worked

Abs and core
35 pts
Glutes
12 pts
Lats
9 pts
Lower back
9 pts
Shoulders
8 pts

Effort and your quota

4/10 effort4fatigue per set

Hold for 15 seconds on each side: move into the pose slowly, breathe steadily, and come out the way you went in. Yoga is practised for control, balance and mobility, never to failure, so this does not change with your limits.

Level: beginner. One round counts like light conditioning work: 12 legs points, 8 push points, 9 pull points, 44 core points.

Prime movers

Obliques, quadratus lumborum and latissimus dorsi of the top side (stretched), intercostals (stretched), deltoids (holding the arms up), gluteus medius.

What to look for

  • Ground both feet evenly; lift up out of the waist before you bend.
  • Bend straight to the side: don’t let the top shoulder roll forward.
  • Press the hips gently the other way.
How the model works, and its limits

One 3D skeleton drives both views. Segment lengths and widths are Winter's anthropometric ratios of height; segment masses and centre-of-mass positions follow Dempster's data. For free-standing lifts the whole-body angle is found numerically so the combined centre of mass of lifter and load sits over the middle of the foot. Arms and legs use two-link inverse kinematics with a pole direction. Rep timing follows a minimum-jerk profile.

Balance is quasi-static, so ballistic lifts are shown slowed down. Cable pull and pad support forces are not modelled. The spine is one rigid segment and joints have no range-of-motion limits or muscle forces.