Passé, extend, lower
Side view
Drag to orbit, pinch or scroll to zoom

Side passe

Side passé

6 reps each side · beginner

The side kick series set-up (lying on the right side, head on the outstretched bottom arm, legs about 20° forward). The top foot slides up the inside of the bottom leg to the knee, the top knee turning up toward the ceiling (passé); the leg extends up toward the ceiling, then lowers long and straight onto the bottom leg. Then the other way: lift long, bend to passé and slide the foot down.

-30°Ankle dorsiflexion
3°Knee flexion
22°Hip flexion
80°Trunk from vertical
171°Arm to trunk
0°Elbow flexion
2Ankle spacing, cm
27Hand spacing, cm
-13Knee outside ankle, cm
–Knee cave, ° inside toe line
–Load left / right, %
-17Pelvis drop, cm

Load and joint demand

Bodyweight: no weights. Joint demand below is your own body's weight in this position.

Shoulder, per side
12 / 12

N·m now / peak over the rep.

Faults

Faults grow with knee bend and apply to lifts standing on the floor. The fault check flags a knee caving more than 10° inside the line of the toes and a load split beyond 60/40. Knee cave shows best in the front camera.

Body

Femur changes keep standing height fixed by shortening or lengthening the torso. Longer femurs force more forward lean in any squat.

Muscles worked

Abs and core
35 pts
Glutes
29 pts
Adductors
22 pts
Quads
16 pts
Lower back
6 pts

Effort and your quota

7/10 effort7fatigue per set

6 slow, controlled reps on each side. Pilates is practised for control, balance and mobility, never to failure, so this does not change with your limits.

Level: beginner. One round counts like light conditioning work: 67 legs points, 41 core points.

Prime movers

Hip flexors and deep external rotators, gluteus medius and minimus, adductors (lowering with control), quadriceps (extending the knee), obliques and quadratus lumborum (holding the trunk still).

What to look for

  • Draw the toes up the inside of the bottom leg, knee turning toward the ceiling.
  • Extend the leg from the passé without letting the hip roll back.
  • Lower long, as if the leg is being pulled away from you.
How the model works, and its limits

One 3D skeleton drives both views. Segment lengths and widths are Winter's anthropometric ratios of height; segment masses and centre-of-mass positions follow Dempster's data. For free-standing lifts the whole-body angle is found numerically so the combined centre of mass of lifter and load sits over the middle of the foot. Arms and legs use two-link inverse kinematics with a pole direction. Rep timing follows a minimum-jerk profile.

Balance is quasi-static, so ballistic lifts are shown slowed down. Cable pull and pad support forces are not modelled. The spine is one rigid segment and joints have no range-of-motion limits or muscle forces.