Move into the pose
Side view
Drag to orbit, pinch or scroll to zoom

Seated side bend

Parsva Sukhasana

hold 20 s each side · beginner · move in slowly, hold, come out the same way

Parsva Sukhasana: sitting cross-legged, the left hand walks out to the mat beside the left hip, the elbow bending, while the right arm sweeps up and over toward the left; the trunk bends about 30° to the left over a level pelvis, both sit bones staying down.

-66°Ankle dorsiflexion
117°Knee flexion
97°Hip flexion
6°Trunk from vertical
32°Arm to trunk
8°Elbow flexion
9Ankle spacing, cm
84Hand spacing, cm
40Knee outside ankle, cm
–Knee cave, ° inside toe line
–Load left / right, %
0Pelvis drop, cm

Load and joint demand

Bodyweight: no weights. Joint demand below is your own body's weight in this position.

Shoulder, per side
7 / 12

N·m now / peak over the rep.

Faults

Faults grow with knee bend and apply to lifts standing on the floor. The fault check flags a knee caving more than 10° inside the line of the toes and a load split beyond 60/40. Knee cave shows best in the front camera.

Body

Femur changes keep standing height fixed by shortening or lengthening the torso. Longer femurs force more forward lean in any squat.

Muscles worked

Abs and core
35 pts
Shoulders
16 pts
Lats
9 pts
Lower back
9 pts

Effort and your quota

3/10 effort3fatigue per set

Hold for 20 seconds on each side: move into the pose slowly, breathe steadily, and come out the way you went in. Yoga is practised for control, balance and mobility, never to failure, so this does not change with your limits.

Level: beginner. One round counts like light conditioning work: 16 push points, 9 pull points, 44 core points.

Prime movers

Obliques, quadratus lumborum and latissimus dorsi of the right side (stretched), intercostals (stretched), deltoids.

What to look for

  • Root the right sit bone down as you reach.
  • Reach up before you reach over; lengthen both sides of the waist.
  • Keep the chest open to the front, not tipping forward.
How the model works, and its limits

One 3D skeleton drives both views. Segment lengths and widths are Winter's anthropometric ratios of height; segment masses and centre-of-mass positions follow Dempster's data. For free-standing lifts the whole-body angle is found numerically so the combined centre of mass of lifter and load sits over the middle of the foot. Arms and legs use two-link inverse kinematics with a pole direction. Rep timing follows a minimum-jerk profile.

Balance is quasi-static, so ballistic lifts are shown slowed down. Cable pull and pad support forces are not modelled. The spine is one rigid segment and joints have no range-of-motion limits or muscle forces.