Roll back
Side view
Drag to orbit, pinch or scroll to zoom

Ring roll-back

8 reps · beginner

The half roll-back holding a pilates ring between the palms, arms reaching forward at shoulder height: sitting tall with the knees bent and the feet flat, the spine rolls back about halfway to the mat while the palms squeeze the ring, pauses, and curls back up as the ring is released.

-39°Ankle dorsiflexion
97°Knee flexion
133°Hip flexion
2°Trunk from vertical
65°Arm to trunk
77°Elbow flexion
20Ankle spacing, cm
42Hand spacing, cm
3Knee outside ankle, cm
–Knee cave, ° inside toe line
–Load left / right, %
0Pelvis drop, cm

Load and joint demand

Bodyweight: no weights. Joint demand below is your own body's weight in this position.

No gravity-based joint demand to show for this exercise.

Faults

Faults grow with knee bend and apply to lifts standing on the floor. The fault check flags a knee caving more than 10° inside the line of the toes and a load split beyond 60/40. Knee cave shows best in the front camera.

Body

Femur changes keep standing height fixed by shortening or lengthening the torso. Longer femurs force more forward lean in any squat.

Muscles worked

Abs and core
35 pts
Chest
12 pts

Effort and your quota

2.5/10 effort2.5fatigue per set

8 slow, controlled reps. Pilates is practised for control, balance and mobility, never to failure, so this does not change with your limits.

Level: beginner. One round counts like light conditioning work: 12 push points, 35 core points.

Prime movers

Rectus abdominis, transversus abdominis, obliques, hip flexors (holding), pectoralis major (squeezing the ring).

What to look for

  • Tuck the tailbone and round the lower back to roll back; keep the ring level.
  • Squeeze as you go back, release as you come up.
  • Keep the feet heavy on the mat.
How the model works, and its limits

One 3D skeleton drives both views. Segment lengths and widths are Winter's anthropometric ratios of height; segment masses and centre-of-mass positions follow Dempster's data. For free-standing lifts the whole-body angle is found numerically so the combined centre of mass of lifter and load sits over the middle of the foot. Arms and legs use two-link inverse kinematics with a pole direction. Rep timing follows a minimum-jerk profile.

Balance is quasi-static, so ballistic lifts are shown slowed down. Cable pull and pad support forces are not modelled. The spine is one rigid segment and joints have no range-of-motion limits or muscle forces.