Move into the pose
Side view
Drag to orbit, pinch or scroll to zoom

Reclined hand-to-big-toe

Supta Padangusthasana

hold 45 s each side · beginner · move in slowly, hold, come out the same way

Supta Padangusthasana with a strap: lying on the back with the left leg long on the mat, a strap looped round the ball of the right foot and held in both hands. The straight right leg rises toward vertical while the arms keep the strap taut and the shoulders stay down.

8°Ankle dorsiflexion
3°Knee flexion
12°Hip flexion
90°Trunk from vertical
12°Arm to trunk
78°Elbow flexion
21Ankle spacing, cm
14Hand spacing, cm
-1Knee outside ankle, cm
–Knee cave, ° inside toe line
–Load left / right, %
0Pelvis drop, cm

Load and joint demand

Bodyweight: no weights. Joint demand below is your own body's weight in this position.

Shoulder, per side
10 / 10

N·m now / peak over the rep.

Faults

Faults grow with knee bend and apply to lifts standing on the floor. The fault check flags a knee caving more than 10° inside the line of the toes and a load split beyond 60/40. Knee cave shows best in the front camera.

Body

Femur changes keep standing height fixed by shortening or lengthening the torso. Longer femurs force more forward lean in any squat.

Muscles worked

Quads
11 pts
Hamstrings
11 pts
Calves and shins
11 pts
Abs and core
9 pts

Effort and your quota

3/10 effort3fatigue per set

Hold for 45 seconds on each side: move into the pose slowly, breathe steadily, and come out the way you went in. Yoga is practised for control, balance and mobility, never to failure, so this does not change with your limits.

Level: beginner. One round counts like light conditioning work: 29 legs points, 9 core points.

Prime movers

Hamstrings and calf of the raised leg (stretched), hip flexors of the lower leg (stretched), quadriceps (holding the knee straight).

What to look for

  • Keep the lower leg long and heavy, its foot flexed.
  • Walk the hands up the strap rather than pulling the leg in; shoulders stay on the mat.
  • Ease off until the knee can stay straight.
How the model works, and its limits

One 3D skeleton drives both views. Segment lengths and widths are Winter's anthropometric ratios of height; segment masses and centre-of-mass positions follow Dempster's data. For free-standing lifts the whole-body angle is found numerically so the combined centre of mass of lifter and load sits over the middle of the foot. Arms and legs use two-link inverse kinematics with a pole direction. Rep timing follows a minimum-jerk profile.

Balance is quasi-static, so ballistic lifts are shown slowed down. Cable pull and pad support forces are not modelled. The spine is one rigid segment and joints have no range-of-motion limits or muscle forces.