TouchesBalanced over midfoot
Side view
Drag to orbit, pinch or scroll to zoom

Laces dribble

Running with the ball

3 reps · beginner

Running with the ball: longer pushes with the laces of the right foot, toes pointed down, the ball about two strides ahead, the left foot stepping between; then a drag-back turns it round. Done out and back.

8°Ankle dorsiflexion
36°Knee flexion
43°Hip flexion
24°Trunk from vertical
35°Arm to trunk
55°Elbow flexion
21Ankle spacing, cm
89Hand spacing, cm
1Knee outside ankle, cm
0°Knee cave, ° inside toe line
50 / 50Load left / right, %
0Pelvis drop, cm

Load and joint demand

A size 5 football and your own bodyweight: no weights.

Lower back
64 / 64
Hip extensors
41 / 41
Knee flexors
2 / 49
Calves
45 / 104

N·m now / peak over the rep.

Faults

Faults grow with knee bend and apply to lifts standing on the floor. The fault check flags a knee caving more than 10° inside the line of the toes and a load split beyond 60/40. Knee cave shows best in the front camera.

Body

Femur changes keep standing height fixed by shortening or lengthening the torso. Longer femurs force more forward lean in any squat.

Muscles worked

Calves and shins
35 pts
Quads
29 pts
Abs and core
22 pts
Adductors
16 pts
Glutes
6 pts

Effort and your quota

6/10 effort6fatigue per set

3 reps (a rep is the whole move as shown): light touches, the ball kept close. Ball mastery is practised for touch, balance and coordination, never to failure, so this does not change with your limits.

Level: beginner. One round counts like light conditioning work: 75 legs points, 22 core points.

Prime movers

Calves, quadriceps, hip flexors, adductors, gluteus medius (stabilising).

What to look for

  • Toes down, push with the laces.
  • Head up while the ball rolls.
  • Push it no further than you can reach.
How the model works, and its limits

One 3D skeleton drives both views. Segment lengths and widths are Winter's anthropometric ratios of height; segment masses and centre-of-mass positions follow Dempster's data. For free-standing lifts the whole-body angle is found numerically so the combined centre of mass of lifter and load sits over the middle of the foot. Arms and legs use two-link inverse kinematics with a pole direction. Rep timing follows a minimum-jerk profile.

Balance is quasi-static, so ballistic lifts are shown slowed down. Cable pull and pad support forces are not modelled. The spine is one rigid segment and joints have no range-of-motion limits or muscle forces.