Move into the pose
Side view
Drag to orbit, pinch or scroll to zoom

Fire log

Agnistambhasana

hold 60 s each side · intermediate · move in slowly, hold, come out the same way

Take care: Skip it with a knee that hurts in this position; slide the top foot onto the mat in front (easy seat) instead.

Agnistambhasana, sitting on a block: the shins stacked parallel to the front of the mat, the left shin on the mat and the right one on top of it, the right ankle over the left knee and the right knee over the left ankle, both feet flexed. From sitting tall, the trunk folds forward over the shins with the hands walking out on the mat.

1°Ankle dorsiflexion
108°Knee flexion
86°Hip flexion
2°Trunk from vertical
17°Arm to trunk
2°Elbow flexion
49Ankle spacing, cm
70Hand spacing, cm
44Knee outside ankle, cm
–Knee cave, ° inside toe line
–Load left / right, %
0Pelvis drop, cm

Load and joint demand

Bodyweight: no weights. Joint demand below is your own body's weight in this position.

No gravity-based joint demand to show for this exercise.

Faults

Faults grow with knee bend and apply to lifts standing on the floor. The fault check flags a knee caving more than 10° inside the line of the toes and a load split beyond 60/40. Knee cave shows best in the front camera.

Body

Femur changes keep standing height fixed by shortening or lengthening the torso. Longer femurs force more forward lean in any squat.

Muscles worked

Glutes
35 pts
Lower back
16 pts

Effort and your quota

4/10 effort4fatigue per set

Hold for 60 seconds on each side: move into the pose slowly, breathe steadily, and come out the way you went in. Yoga is practised for control, balance and mobility, never to failure, so this does not change with your limits.

Level: intermediate. One round counts like light conditioning work: 35 legs points, 16 core points.

Prime movers

Gluteus maximus, piriformis and deep hip rotators (stretched), gluteus medius, spinal erectors.

What to look for

  • Flex both feet to protect the knees.
  • Sit on a block so the knees can come closer to stacking.
  • Fold only as far as the knees stay comfortable.
How the model works, and its limits

One 3D skeleton drives both views. Segment lengths and widths are Winter's anthropometric ratios of height; segment masses and centre-of-mass positions follow Dempster's data. For free-standing lifts the whole-body angle is found numerically so the combined centre of mass of lifter and load sits over the middle of the foot. Arms and legs use two-link inverse kinematics with a pole direction. Rep timing follows a minimum-jerk profile.

Balance is quasi-static, so ballistic lifts are shown slowed down. Cable pull and pad support forces are not modelled. The spine is one rigid segment and joints have no range-of-motion limits or muscle forces.