Move into the pose
Side view
Drag to orbit, pinch or scroll to zoom

Bridge pose

Setu Bandha Sarvangasana

hold 30 s · beginner · move in slowly, hold, come out the same way

Take care: Keep the head still and the weight on the shoulders, not the neck; lift lower or skip it with a neck injury.

Setu Bandha Sarvangasana: lying on the back, knees bent and feet flat hip-width, heels a hand’s length from the seat, arms long beside the body, palms down. The hips lift until the thighs are about parallel and the chest opens toward the chin, the weight on the shoulders and feet; the back of the head stays still on the mat.

-14°Ankle dorsiflexion
141°Knee flexion
65°Hip flexion
90°Trunk from vertical
14°Arm to trunk
23°Elbow flexion
20Ankle spacing, cm
44Hand spacing, cm
4Knee outside ankle, cm
–Knee cave, ° inside toe line
–Load left / right, %
0Pelvis drop, cm

Load and joint demand

Bodyweight: no weights. Joint demand below is your own body's weight in this position.

Shoulder, per side
11 / 11

N·m now / peak over the rep.

Faults

Faults grow with knee bend and apply to lifts standing on the floor. The fault check flags a knee caving more than 10° inside the line of the toes and a load split beyond 60/40. Knee cave shows best in the front camera.

Body

Femur changes keep standing height fixed by shortening or lengthening the torso. Longer femurs force more forward lean in any squat.

Muscles worked

Glutes
35 pts
Hamstrings
29 pts
Lower back
22 pts
Quads
16 pts
Chest
4 pts
Abs and core
4 pts

Effort and your quota

8/10 effort8fatigue per set

Hold for 30 seconds: move into the pose slowly, breathe steadily, and come out the way you went in. Yoga is practised for control, balance and mobility, never to failure, so this does not change with your limits.

Level: beginner. One round counts like light conditioning work: 80 legs points, 4 push points, 26 core points.

Prime movers

Gluteus maximus, hamstrings, spinal erectors, quadriceps; hip flexors and pectoralis major stretched.

What to look for

  • Feet hip-width and parallel, knees over the ankles.
  • Press through the feet and arms to lift the hips; keep the knees from splaying.
  • Don’t turn the head once you are up: the neck is carrying weight.
How the model works, and its limits

One 3D skeleton drives both views. Segment lengths and widths are Winter's anthropometric ratios of height; segment masses and centre-of-mass positions follow Dempster's data. For free-standing lifts the whole-body angle is found numerically so the combined centre of mass of lifter and load sits over the middle of the foot. Arms and legs use two-link inverse kinematics with a pole direction. Rep timing follows a minimum-jerk profile.

Balance is quasi-static, so ballistic lifts are shown slowed down. Cable pull and pad support forces are not modelled. The spine is one rigid segment and joints have no range-of-motion limits or muscle forces.